High Park Electrician for Pre-1950 and Heritage Homes
In Toronto's west end, High Park's 1890s-1940s detached and semi-detached homes on the Bloor West Village and Roncesvalles corridors carry pre-war electrical systems with original two-wire ungrounded branch circuits and 60-100A service that usually needs an upgrade before a Level 2 EV charger or heat pump goes in. Toronto Electrical Contractor covers panel upgrades, knob-and-tube rewiring, EV charger installation, aluminum wiring remediation, emergency electrician response, and electrical safety inspections across High Park - ECRA/ESA licensed, ESA permit handled, 5-year workmanship warranty.
ESA
Licensed Contractor
Under
Response
Permits
Included
★ 4.9
Google Rating
Knob-and-Tube, Fuse Boxes and Other Pre-War Wiring Problems
Most calls fall into four buckets. Each has a code-driven answer and an insurance-ready paper trail.
Layered Wiring Eras in a Pre-1950 Home
Bloor West Village and Roncesvalles homes commonly carry three or four eras of wiring on the same panel: 1920s knob-and-tube, 1970s aluminum additions, original fuse box. Full safety inspection first, then a prioritized scope with insurance-critical items handled first.
Aluminum Branch Wiring From a 1970s Addition
Junction Triangle and Indian Road area homes often have aluminum wiring isolated to a single rear addition from the 1970s. ESA-approved AlumiConn pigtailing on every receptacle in scope, with the documentation Ontario insurers ask for at renewal.
Plaster Ceiling LED Pot-Light Retrofit
Roncesvalles and Bloor West Village plaster ceilings need careful technique for LED pot-light retrofits. IC-rated remodel cans, minimal-cut openings, plaster patching where required, and proper insulation contact rating throughout.
Fuse Box Conversion in a Swansea Bungalow
Swansea bungalows still running on original screw-in fuse boxes can't carry an EV charger or modern HVAC load. Fuse-box-to-breaker conversion with a 200A service swap, ESA permit, and Toronto Hydro reconnect, complete in one day.
Residential Electrical Services From Panels to Pot Lights
Full residential and small-commercial scope. Every project ESA-permitted under our LEC.
Emergency Electrician
24/7 response across the GTA in High Park and surrounding areas.
Learn moreEV Charger Installation
Level 2 home installs in High Park and surrounding areas.
Learn morePanel Upgrade
100A → 200A + Federal Pacific replace in High Park and surrounding areas.
Learn moreKnob & Tube Replacement
Insurance-driven heritage rewires in High Park and surrounding areas.
Learn moreAluminum Wiring
ESA-approved pigtailing in High Park and surrounding areas.
Learn moreSafety Inspection
Pre-purchase + insurance reports in High Park and surrounding areas.
Learn moreFrom Safety Inspection to ESA Sign-Off
Pre-1950 streets around Bloor West Village, Roncesvalles, and Swansea often carry three or four eras of wiring layered onto the same panel, so a full safety inspection comes before any scope decision. Toronto Electrical Contractor pulls every ESA permit in-house, uses IC-rated remodel cans on plaster ceilings, coordinates the Toronto Hydro disconnect and reconnect on service upgrades, and prioritizes insurance-critical items first when a layered scope shows up.
01
Free Estimate
Send us photos and a description, or have us out for a site visit. You get a flat-rate quote within 24 hours. Permits and inspection costs already baked in.
02
In-House Permit
Our master electrician files the ESA permit under our LEC number. You never deal with paperwork or pay separate permit fees.
03
Scheduled Install
We work around your schedule, including evenings and weekends for emergencies. Same-day for urgent panel and emergency work.
04
ESA Inspection
ESA signs off on the work. We hand you the Certificate of Acceptance, the document insurers and buyers ask for.
Need an Electrician in High Park Today?
Free estimates on residential projects. Same-day quotes for emergencies. Permits and ESA inspection always included.
Licensed, Permitted, and Insurance-Ready on Every Job
- 01
ESA-Licensed Contractor
Every truck carries an ESA-licensed technician. Permits get pulled in our name, inspections happen on schedule, and you never deal with the paperwork.
- 02
Permits Always Included
Quotes already cover the ESA permit and inspection. No surprise add-ons, no "homeowner-pulled" liability shifts to you.
- 03
24/7 Emergency Response
Sparks, smoke, or total power loss: we respond across Toronto and the inner GTA in under 60 minutes, including weekends and holidays.
- 04
Older-Home Specialists
Knob-and-tube, aluminum wiring, Federal Pacific Stab-Lok, fuse boxes: we work on pre-1980 GTA housing every single day.
- 05
Flat-Rate Pricing
You get a number before we start, not after. No hourly drift, no after-hours surcharges hidden in the fine print.
- 06
Insurance-Ready Documentation
Every project ends with an ESA Certificate of Acceptance and a written sign-off insurers across Ontario accept for renewal.
Wiring Know-How From Bloor West Village to Swansea
Toronto Electrical Contractor is an ESA-licensed electrical contractor providing residential electrical services and small commercial work across High Park and Toronto's west end, one of our primary coverage zones in the GTA. The streets around Bloor West Village, Roncesvalles, and High Park concentrate a high share of pre-1950 Edwardian and Tudor homes, many with layered electrical histories: original knob-and-tube from the 1920s, aluminum-wired additions from the 1970s, and original fuse boxes in the basement. A complete safety inspection before finalizing the scope is standard practice here.
Plaster ceilings are common throughout, which complicates LED pot-light retrofits in semi-detached houses, row houses, and duplex conversions alike. Our team uses IC-rated remodel cans and minimal-cut techniques developed specifically for the plaster work typical of The Junction, Junction Triangle, and the streets east of the park. In Swansea, the detached homes and bungalows between Bloor Street and the Humber River often still run on 60A service and screw-in fuses, so fuse-box-to-breaker conversions with a 200A service swap and a coordinated Toronto Hydro disconnect and reconnect are a regular scope there.
Searching for an electrician near you in High Park? Our teams reach the area via the Gardiner Expressway and the Queen Elizabeth Way, with High Park Station, Keele Station, and Runnymede Station on the Bloor-Danforth line providing transit context. Emergency response runs 24/7 with arrival in under 60 minutes, from Parkdale and Indian Road to Runnymede and Swansea.
Landmarks & Surrounding Area
- High Park
- Grenadier Pond
- Bloor West Village BIA
- Roncesvalles Village
- Colborne Lodge
Access Routes
Accessible via the Gardiner Expressway and QEW, with TTC subway access at High Park, Keele, and Runnymede stations on the Bloor-Danforth line.
Areas We Serve in High Park
- ✓ Bloor West Village
- ✓ Roncesvalles
- ✓ Swansea
- ✓ The Junction
- ✓ Junction Triangle
- ✓ Indian Road area
- ✓ Parkdale
- ✓ Runnymede
Reviews From Roncesvalles, Junction Triangle and Swansea Homeowners
Recent High Park jobs across the neighbourhoods we cover most often. Average 4.9/5 across our GTA work.
"Roncesvalles plaster ceiling LED pot lights, twelve fixtures across the kitchen and family room. They used IC-rated remodel cans, cut just enough to fish the wire, and patched what they did open. The ceiling looks original and the kitchen is finally usable for cooking after dark."
Magda N.
Roncesvalles, High Park
"Aluminum wiring scare on a Junction Triangle home we'd just bought. The 1970s rear addition was the only aluminum-wired part of the house. They pigtailed every receptacle with AlumiConn, wrote up the documentation our insurer asked for, and the renewal went through clean."
Paul S.
Junction Triangle, High Park
"Swansea bungalow with the original fuse box and a 60A service. They quoted the fuse-box-to-breaker conversion and 200A upgrade as a flat rate, did the work in one day, and coordinated the Toronto Hydro reconnect. ESA Certificate followed two weeks later."
Catherine L.
Swansea, High Park
High Park Electrician FAQs
How fast can an electrician get to my High Park home?
+
Emergency electrical response is available 24/7 across High Park, Roncesvalles, Bloor West Village, and Swansea, with arrival in under 60 minutes. There is no call-out fee during business hours; after-hours emergency calls carry a $150 dispatch fee plus labour. Non-emergency work is booked after a free estimate.
How much does an electrician cost in High Park?
+
We quote flat rates instead of open-ended hourly billing, and residential estimates are free. As of 2026, typical High Park projects run $250-$450 for an electrical safety inspection, $800-$1,500 for a Level 2 EV charger, $1,800-$3,500 for a 100A to 200A panel upgrade, and $150-$300 for a ceiling fan installation, with ESA permits included.
How much does knob-and-tube replacement cost in an older High Park home?
+
Full knob-and-tube rewiring of a typical pre-1950 High Park or Bloor West Village home runs $8,000-$15,000 (2026 pricing), depending on house size, plaster access, and whether the panel is upgraded at the same time. Most Ontario insurers require knob-and-tube removal, and the ESA Certificate of Acceptance we provide is the document they ask for.
How do I check that an electrician in High Park is licensed?
+
In Ontario, anyone doing electrical work for hire must hold a Licensed Electrical Contractor (LEC) licence from the Electrical Safety Authority (ESA). Ask for the contractor's LEC number and look it up in the ESA's online contractor search, then confirm an ESA permit is filed for your job. Toronto Electrical Contractor is ESA-licensed and pulls every permit in-house.
My pre-war home near High Park has multiple eras of wiring. How do you approach the inspection?
+
We start with a full safety inspection that identifies all wiring systems present: original knob-and-tube, any post-war aluminum additions, and the panel condition. You get a written report and a prioritized scope with insurance-critical items first, followed by capacity upgrades and convenience work.
Can you retrofit LED pot lights in a plaster ceiling in Roncesvalles?
+
Yes. Plaster ceiling retrofits are a regular part of our High Park and Roncesvalles work. We use IC-rated remodel cans with minimal cutting, and plaster patching is included where openings are required.
What does aluminum wiring remediation cost in a Junction Triangle home?
+
ESA-approved pigtailing with AlumiConn connectors runs $75-$150 per device. A typical Junction Triangle home with 20-30 aluminum terminations from a 1970s addition runs $1,500-$4,000. Full copper replacement is quoted separately for larger scopes.
Can you convert a fuse box to a breaker panel in an older High Park-area home?
+
Yes. Fuse-box-to-breaker conversions are common in the Swansea and Indian Road area of High Park. We upgrade the service to 200A, install a modern breaker panel, pull the ESA permit, and coordinate the Toronto Hydro disconnect and reconnect, all in one day for most residential scopes.
Book a Free Estimate With a Licensed Electrician
Free estimates on residential projects. Same-day quotes for emergencies. Permits and ESA inspection always included.